www.MSruns.com read only forum (Jan.15,2018)

I managed to have another play with this today, and I made a subframe to take the GTS1000 fuel tank and another for the radiator. They will rotate into position on the rig, and close for storage, which at the same time allows me to use say the fuel tank on another project. The fuel tank has a pump i...

I haven't posted an update for a while, as been working too much and had issues getting the bike to run after upgrading the firmware. It should have been better, but it wasn't, and every time I went round to work on it, there was always something stopping me, from working on the Thunderace engine. I...

Check out this thread here.

This guy got his Kawasaki to start reliably, and he's one happy dude now.

... I think the long tooth trigger is causing some problems so I tried reducing it to the width of the VR sensor....... It will be just this, there is on the MIcroSquirt forum ZGRX1000 who was having the same problems, and it was suggested he removes the long tooth. He has bought a different crank ...

Another day, another dollar as they say...I never really understood Secondary Load Parameters in the MSEXtra options. So there is me adjusting the VE Table to suit small throttle opening changes, and after the rescaling, the response is getting better. I actually changed this table and selected Seco...

Still trying to work out what is happening with TunerStudio, and whether it's a Dropbox issue, but I don't really remember any issues before like this. :? Had another go at a cold start again tonight, and although I had a strong battery, I was getting a little kickback through the throttle bodies an...

Had another go this Sunday, trying to sort out cranking pulsewidths, and WUE. Strangely, had another Project Config error in TunerStudio :x It was a corrupted project file again, and when I deleted the surplus project.properties files and edit the remaining I was able to get into the project again. ...

Back on the bike engine again, another MicroSquirt with non LLO set up, and after two attempts started fine. First churn on the starter, after three seconds, it fired, idled briefly, then died. MSExtra3.1.0 is definitely different to my previous 3.0.3 versions. Going to have another go tomorrow, wit...

Hopefully after work today, I can try and get the bike started from cold, and calibrate my Innovate LC-1, and get back to where I was before I had a config error. I'm not where I was before, but at least I got a cold start, after pumping up the cranking pulsewidths to 200%. I then had to tweak the ...

Hopefully today, on the way back from work, I can tweak the bikes starting & WUE some more, and as a backup I have three MicroSquirts all loaded with MSExtra3.1 & the same msq. Well I did, except using the same msq settings in MSExtra3.1, the bike wouldn't start without additional fuel (bra...