1979 Chevy Silverado 355 Twin Turbo

For vehicles not yet running, but in the process of converting to MegaSquirt (ask a moderator to move your thread once you are running).
Post Reply
hiperf402
MegaSquirt Newbie
Posts: 3
Joined: Sun Oct 03, 2010 7:31 am

1979 Chevy Silverado 355 Twin Turbo

Post by hiperf402 »

My current project is a 1979 Chevy Silverado Pickup 355 Twin Turbo Intercooled V8.


Engine:
SBC 350 bored .030. 4 valve relief flat top pistons. 8.5-9:1 compression
Summit Sum-1105 cam
Stock heads with 1.96 int 1.60 exh stainless valves
TPI intake with FAST 60 lb/hr injectors
STR Cast iron t3/t4 manifolds with T04E Hybrid Turbos .63 A/R Turbine .60 A/R Compressor
38mm wastegates set @ 8 psi with manual controller to be installed for more boost :D
2 1/2 inch hot side tubing feeding 2 in 1 out intercooler with 3 inch cold tubing
OBX 700 Hp fuel pump, stock FPR

Electronics:
Megasquirt II with PCB v3.0 running B&G 2.890 firmware
8 pin hei module
Tech Edge wideband oxygen sensor. planning for duals though.

Current status as of today is that I still need to wire and install o2 sensor, vacuum check valves and blow-off valves, manual boost controller and map tubing. I had running very briefly because I couldn't contain myself to wait. I hope pics turn out.
You do not have the required permissions to view the files attached to this post.
355 SBC Twin Turbo .63 turbine .60 compressor
MSII v3.0 board running ver 2.890 code
Tech edge wideband
knock enabled
tuned-port injection 65 lb/hr injectors
hiperf402
MegaSquirt Newbie
Posts: 3
Joined: Sun Oct 03, 2010 7:31 am

Re: 1979 Chevy Silverado 355 Twin Turbo

Post by hiperf402 »

Forgot to add this shot as well.
You do not have the required permissions to view the files attached to this post.
355 SBC Twin Turbo .63 turbine .60 compressor
MSII v3.0 board running ver 2.890 code
Tech edge wideband
knock enabled
tuned-port injection 65 lb/hr injectors
Post Reply