Page 1 of 1

'87 190E 2.3 8v

Posted: Thu Feb 20, 2014 11:47 am
by Nfsjunkie91
Hey everyone,

Built and tested my MS2 v3.0 DIY kit from DIYAutoTune, and started installing it in my 190E. I've been jacked around with fuel line fittings, so I haven't gotten that part going yet, but I did successfully take control of the PWM idle valve and have it fairly well tuned at this point. I'm starting with fuel-only, but will be going to a hall-effect sensor in the future, probably in 2 months or so. I'm also using a CLT based "initial value" look up table, as I'm not using a TPS at this point so the "last value" setting gets a little funky.

Re: '87 190E 2.3 8v

Posted: Mon Jan 19, 2015 8:18 am
by armol
Hi I just converted my 88 190e 2.3 8v to MS1, no TPS , fuel only. way different from the CIS stuff. runs good.