Scott Campbell, 1969 Camaro

Chevrolet, Pontiac, Buick, Oldsmobile, Cadillac, Saturn, Geo, Holden, Vauxhall, etc.
Post Reply
Scott
Running MegaSquirt
Posts: 1
Joined: Sat Apr 03, 2004 10:38 am
Location: Colorado Springs, CO / USA

Scott Campbell, 1969 Camaro

Post by Scott »

Name: Scott Campbell

Vehicle: 1969 Camaro

Engine: 427cid small block, AFR heads, Comp cam, etc. (Desktop Dyno projected 435 HP)

Injection: Holley 900cfm 4bbl TBI with four 85lb/hr injectors on a Weiand 8004 manifold

Description: Much nicer hardware/software than the Holley ProJection 4Di.

Image

Update:
I added the EDIS stuff, now I'm running MSnEDIS. It's really cool to have detailed timing control, and get rid of that miserable spring and weight mechanism that was always wrong before. My timing is still wrong (probably a little worse at the moment), but at least now I can tweak it and hopefully make it better.

Here is a little write-up I did for how I setup and mounted the triggerwheel:
http://www.planetcampbell.us/TriggerWhe ... lation.htm

The EDIS8 module (Lincoln 4.6L), coil packs/plug wires (Explorer), and the VR sensor (ABS sensor for Ford Aspire) all came from eBay. Total cost with shipping was around $40USD. For wires, I grabbed a harness from a car at the local wrecker and stripped out individual wires as needed, $5USD.

Crank-triggered timing is great. Timing jitter dropped from ~12degrees to close to zero with the EDIS system.
Post Reply