new beta test MSII-SEQUENCER install/test

Dodge, Plymouth, Chrysler, Eagle, Jeep, AMC, etc.
Post Reply
sheriff
MegaSquirt Newbie
Posts: 1
Joined: Thu Feb 23, 2006 4:30 pm

new beta test MSII-SEQUENCER install/test

Post by sheriff »

my engine -- +.040 - 440 - 1978-dodge motor home engine- eagle stroker crank (4.150") - srp forged pistons (10.1 c/r) - comp cams hyd roller camshaft and lifters (.538 lift) - comp roller rockers - balanced rotating assy - extensive head work - converted intake manifold to port injection w/ 900 cfm holley tb - 42# injectors - gm ls2 truck coil packs - 36-1 vr sensor - stock dist converted for cam sensor output. this gives me full sequential fuel and ignition. sequencer is for the most part set-up and tested. only minor tweaks for warm-up enrichment due to weather changes. i previously was running fuel only - same engine - same intake and tb - msI w/flyback board - batch fired injectors - stock ignition - sequencer is a vast improvement in performance over my previous set-up. engine is installed in an 88 dodge d150 - 727 tx - 2wd. ==jimk==
Post Reply