Vehicle: 2002 Mazda Miata/MX-5
Engine: 1.8lt, inline 4, 16v, VVT, 10:1 compression ratio
Injection: Port injection, alternating, 270cc injectors, stock manifold.
Description: Retrofitted a CAS from a '96 1.8 Miata - apparently you can't use the stock crank and cam sensors as they are incompatible, requiring many changes to the MS. I am using an external MAP sensor in the engine bay made from GM, I find it more convinient to route wires through the firewall than a vaccum hose. I am using the stock coolant and air temperature sensors. I measured the bias resistor in the stock ECU and based on the resistance/temperature plot of the said sensors (available in the Mazda service manual) I downloaded the proper sensor data using EasyTherm. For exhaust gas oxygen measurement, I got an LM-1 from Innovate Motorsports.
I generated a basic VE table using MegaTune, and once the car was warmed up using the stock ECU, I switched to MS and the idle was exactly as smooth as with the stock ECU - albeit a little too rich. At this point I am still tuning my air temperature correction and warmup settings, and things are looking great. Ignition and idle control (via a PWM idle control solenoid) are still left to the stock ECU, however I will also do ignition as soon as I am satisfied with my injection tuning.
I have an incar PC so I am able to checkout all running parameters without carrying a laptop with me all the time.
Obligatory pictures:
![Image](http://users.forthnet.gr/ath/twikicore/dsc00634_1.jpg)
![Image](http://users.forthnet.gr/ath/twikicore/dsc00619_1.jpg)
![Image](http://users.forthnet.gr/ath/twikicore/dsc00620_1.jpg)
![Image](http://users.forthnet.gr/ath/twikicore/dsc00635_1.jpg)
![Image](http://users.forthnet.gr/ath/twikicore/dsc00650_1.jpg)
![Image](http://users.forthnet.gr/ath/twikicore/dsc00670_1.jpg)
![Image](http://users.forthnet.gr/ath/twikicore/dsc00672_1.jpg)
![Image](http://users.forthnet.gr/ath/twikicore/dsc00665_1.jpg)