5.7 Hemi Crate Engine
5.7 Hemi Crate Engine
It's looking good after initial runs on engine stand. Lots of tuning to do but very positive.......log looks good.
I wish it weren't winter here.
Big thanks to Shawn (boost junkie).
Here's a few pics on the stand..........nothing on the motor is finished yet but it'll be looking good soon..........going to Detroit Autorama in 18days!!!
I'll update the pics once the motor is in the car.
Also, here is my msq..........very rough tune......but running. This msq will not work with a stock hemi crate engine. This motor has a very big cam. However the ignition settings would be the same.
-
- MegaSquirt Newbie
- Posts: 2
- Joined: Tue May 11, 2004 7:58 am
- Location: dallas texas usa
Re: 5.7 Hemi Crate Engine
Is the code for stock crank trigger available?
I'm a newbie, I know nothing about this but know a guy that does.
Thanks
Re: 5.7 Hemi Crate Engine
It's running fairly well now. We had issues to overcome with some bad injectors (Venom are NFG) and a wonky crank sensor. Much better now. In the spring we will do some more tuning and get it dialed in better.
hemiaction is running this setup in cold weather and tells me that you should use 560 ohm resistors in place of the 660 ohm resistors recommended in the manual for the COP wasted spark setup. I agree as the spark is a little weak with the 660's in place.
The code for the stock crank trigger on these engines is as I said before. Boostjunkies NGC code variant. Originally written for Neon I4 engines. I figured out the trigger settings to use this code for the Hemi V8......they have been posted and are in the msq file above. That is an old msq the fuel maps are probably no where close for a stock hemi but the trigger and spark settings should be right.
-
- MegaSquirt Newbie
- Posts: 1
- Joined: Wed Jan 13, 2010 10:01 am
Re: 5.7 Hemi Crate Engine
-
- MegaSquirt Newbie
- Posts: 1
- Joined: Fri Jul 23, 2010 12:47 pm
Re: 5.7 Hemi Crate Engine
janni_ruda wrote:hi. is it a hallsensor on the cranktrigger? or a VR sensor? and do you need 8 vb921? doesen´t it work with 4 and wastedspark? thanks johan
It is a hall sensor (3 wires) and you DO need 8 vb921's per the MS2 manual. Each coil gets it very own vb921 even though it is wasted spark.