www.MSruns.com read only forum (Jan.15,2018)

ok cool my car is an obd1 already.

well iv got the MS v3.0 and im in the middle of building it. im unsure of what setup to use for the timing, its a coil pack car.. I think i should use GMs DIS but it talks about using MS2. anyone know what i should do

8 or 9 degrees of total ignition is conservative even at 21lbs of boost with pump gas. What compression ratio is the engine at? What is your normal fuel octane level?

hi lapkritis my compression is 8:5:1 and the fuel 97 octane the 8 or 9 degree total timing is an area never seen on my spark table my timing at 21psi is from 14 to 18 deg if you look at the datalog screenshot on page 1 @23psi im at 16.5 deg timing

tuning coming on well then red eye ,,,