Ford Kent X-flow MS2 PCB3.0 files?
-
- MegaSquirt Newbie
- Posts: 2
- Joined: Sun Apr 14, 2013 3:28 pm
Ford Kent X-flow MS2 PCB3.0 files?
Its got Monitor_v2.920.abs.s19 firmware and tunerstudio 2.08 with megasquirt-II_2920.ini
I want to use ms2_extra.s19 and megasquirt-ii.ms2extra.ini. The firmware flashes fine but it wont connect in tunerstudio gives a serial error. This I assume I should ask on the msextra.com forum.
What im looking for at the moment is a base table for ignition and fuel. Does anyone have anything that would make for a good starter?
Cheers
-
- MegaSquirt Newbie
- Posts: 8
- Joined: Thu Dec 29, 2005 2:04 pm
- Location: uk scotland ayrshire
Re: Ford Kent X-flow MS2 PCB3.0 files?
If you know/find your injector flow rate, you can use the calculated fuel table generator, this in most cases will get you running, for spark simply mimic an old x flow dizzy, you can refine once you are driving, my advice is buy an innovate wideband lambda (lm2 would be my choice) feel free to pm or mail me, are you in the uk ?
go on, fit a turbo "you know you want to"
-
- MegaSquirt Newbie
- Posts: 2
- Joined: Sun Apr 14, 2013 3:28 pm
Re: Ford Kent X-flow MS2 PCB3.0 files?
I dont know much about the software and tuning yet as im still getting things to work but im reading up on it.
Do you have a xflow?
Im in New Zealand.