MS2-e 16vT Distributor Setup
Posted: Wed Jun 09, 2010 9:22 pm
Just wanted to toss this up here as a working distributor setup for MS2-e, didnt run across any in the searches and had a bit of a time sorting through the rising edge or falling edge triggering - thanks to Paul_VR6 for the help on that
Seems if you follow this (for 5v) from the MS2-e manual
you need to use falling edge detection
and if you follow the jumper procedure outlined on DIY's site, you need to follow their setup guide for rising edge detection.
Attached my msq file - NOT tuned beyond idling and low speed maneuvering - for reference
Complete setup is a stock 16v distributor, MSD driving the coil, big injectors (hence the odd req_fuel #)
MS2-e 2.1.0d on a v3 board
enjoy
Seems if you follow this (for 5v) from the MS2-e manual
you need to use falling edge detection
and if you follow the jumper procedure outlined on DIY's site, you need to follow their setup guide for rising edge detection.
Attached my msq file - NOT tuned beyond idling and low speed maneuvering - for reference
Complete setup is a stock 16v distributor, MSD driving the coil, big injectors (hence the odd req_fuel #)
MS2-e 2.1.0d on a v3 board
enjoy